Autoflame Lead for Pressure Detector. Lead10001

Overview
The Autoflame LEAD10001 is a dedicated connection lead designed to interface with Autoflame pressure detectors, providing reliable wiring between the sensor and the control module. It ensures proper signal transmission and compliance with the system’s safety and detection requirements.

Key Features

• Specifically manufactured as the matching lead for Autoflame pressure detectors.

• Enables sealed and secure connection between detector and control system.

• Facilitates ease of installation and ensures compatibility with system accessory wiring standards.

• Designed for long-term durability in industrial boiler, HVAC, burner and control environments.

Main Benefits

• Ensures correct wiring and avoids generic leads that may compromise sensor functionality.

• Simplifies installation process when integrating the pressure detector into larger combustion or HVAC systems.

• Provides peace of mind for service and safety checks by using the manufacturer-specified lead accessory.

Technical Highlights

• Part number: LEAD10001 – this lead is sold separately because the accompanying detector is supplied with a plug but without the lead.

• Typical accessory weight very light (cable assembly only).

• Intended use with Autoflame pressure detector modules in boiler and burner control systems.

Installation & Safety Notes

• Install the lead according to the wiring diagram provided with the detector or burner controller.

• Ensure connections are secure and protected from mechanical strain or environmental damage.

• Check that the lead length and routing comply with local wiring regulations and don’t introduce unnecessary wiring loops or interference.

• Periodically inspect the lead for signs of wear, abrasion or insulation damage in industrial settings.

Applications

• Wiring accessory for Autoflame pressure detectors in burner systems.

• Use in boiler pressure detection modules for monitoring fuel or air pressures.

• Retrofit or service applications where the original detector lead must be replaced or extended.